Peripheral setup -9, 5 peripheral setup – Acrosser AR-B1320 User Manual
Page 46
A
A
R
R
-
-
B
B
1
1
3
3
2
2
0
0
U
U
s
s
e
e
r
r
’
’
s
s
G
G
u
u
i
i
d
d
e
e
4-9
4.5 PERIPHERAL
SETUP
This section is used to configure the peripheral features.
Figure 4-5 BIOS: Peripheral Setup
Hard Disk Delay
If this option is set to Disabled and the system BIOS executes too fast, the result is that the BIOS can’t
find the hard disk drive. Therefore, it is recommended to select a hard disk delay period to prevent the
BIOS from executing too fast.
Available options: 3 Sec, 5 Sec, 10 Sec, 15 Sec.
OnBoard Primary IDE
This option specifies the onboard IDE controller channels that will be used.
Available options: Enabled, Disabled
OnBoard FDC
This option enables the floppy drive controller on the AR-B1320.
Available options: Enabled, Disabled
OnBoard Serial Port1
This option enables the serial port on the AR-B1320.
Available options: Disabled, 3F8h, 2F8h, 3E8h, 2E8h
OnBoard Serial Port1 IRQ
This option selects the IRQ for the onboard serial port1.
Available options: 3, 4, 5, 9
OnBoard Serial Port2
This option enables the serial port2 on the AR-B1320.
Available options: Disabled, 3F8h, 2F8h, 3E8h, 2E8h