Advanced cmos setup -4, 3 advanced cmos setup – Acrosser AR-B1320 User Manual
Page 41
A
A
R
R
-
-
B
B
1
1
3
3
2
2
0
0
U
U
s
s
e
e
r
r
’
’
s
s
G
G
u
u
i
i
d
d
e
e
4-4
4.3
ADVANCED CMOS SETUP
The
your system performance, or let you set up some system features according to your preference.
Some entries here are required by the CPU board’s design to remain in their default settings.
Figure 4-3 BIOS: Advanced CMOS Setup
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
These options determine the priority of the bootup devices, which the system looks for first to boot the
system. According to the default setting, the system checks first the hard disk and then the floppy drive,
and last the CDROM.
Available options: Disabled, IDE-0, IDE-1, IDE-2, IDE-3, Floppy, ARMD-FDD, ARMD-HDD, CDROM,
SCSI, NETWORK
Boot From Card Device
Select Yes to boot up the system from the SSD BIOS, and No to boot the system from the system’s
onboard BIOS.
Available options: No, Yes
Note: It is recommended to configure this function at it’s default setting, Yes.
Try Other Boot Device
If you have other bootup device beside the devices that have been mentioned above, such as IDE-0,
IDE-1, IDE-3, IDE-4, Floppy, ARMD-FDD, ARMD-HDD, CDROM, SCSI, and Network, choose Yes.
This device is prior to the above devices mentioned above.
Available options: No, Yes
Available Options