Deutsche Telekom T-Eumex 504PC SE - Manual (Page 19)

11
Connecting Devices
Regulations permit the general public to connect the Eumex 504PC SE to the
Deutsche Telekom network. You can thus connect the Eumex 504PC SE yourself if
the following conditions are met:
• The device may only be connected to a basic Euro-ISDN connection. Do not under
any circumstances connect it to lines or equipment in the analogue network. Never
connect it to an ISDN tie line. Failure to observe these conditions can result in
faulty operation or damage to the Eumex 504PC SE as well as to the network.
• The basic Euro-ISDN connection must be used in conjunction with a network ter-
minator (NTBA) as supplied by Deutsche Telekom. The connection must be the
multi-terminal type.
Insert the Eumex 504PC SE connector cable in the corresponding socket of the
NTBA. Insert the other end in the socket marked "ISDN" on the bottom left-hand side
of the Eumex 504PC SE.
Connecting the Eumex 504PC SE to T-ISDN
NTBA
T-ISDN
TAE socket
230 V
230 V
Eumex
504PC SE
Eumex
504PC SE