Dimplex DFB6016 - Manual (Page 8)

8 www.dimplex.com
restrict air circulation. If
installing the fireplace in a
carpeted area, place a one-
piece, solid, flat surface under
the fireplace insert. Ensure
that all four of the insert’s feet
rest securely on this surface.
Existing Fireplace
Installation
Seal all drafts and vents 1.
with non-fibrous insulation
materials to prevent chimney
debris from falling into the
fireplace insert. Do not install
into an existing fireplace
that is prone to leaks or
dampness.
Cap the top of the chimney
2.
flue to prevent rain from
entering.
Plan your electrical power 3.
supply (refer to noTE 1).
The power cord can run along
4.
the front of the hearth to an
outlet near the fireplace.
WARNINg: To prevent
personal injury you should
hire a professional to cap the
chimney flue or cut a hole
in the existing fireplace for
wiring. If you return your
existing fireplace to its original
use (example: wood burning),
it should be inspected by the
local building department prior
to use to reduce the risk of fire
and personal injury.
New Wall Construction
select a suitable location that 1.
is not susceptible to moisture
and is away from drapes,
furniture and high traffic.
Place the fireplace in the
2.
desired location to see how it
will look in the room.
mark the desired location
3.
on the floor and store the
fireplace in a safe, dry and
dust free location.
Use studs to frame an
4.
opening of 30 ¾ inch (78.1
cm) wide X 25 ¾ inch (65.4
Site Selection and Preparation
Figure 1
Air Circulation Areas
Rubber
Feet
25 ½”
(64.8 cm)
30 ¼”
(76.8 cm)
11 ½”
(29.2 cm)