Dimplex DFB6016 - Manual (Page 12)

12 www.dimplex.com
pressed.
The fireplace can be turned off
at any point by pressing the OFF
button on the remote control
transmitter.
Level 1 : The flame effect
is turned on and the first red
indicator light illuminates.
Level 2 : The flame effect
remains on, the heater is
activated to the low heat
setting, and the first and
second red indicator lights
illuminate.
Level 3 : The flame effect
remains on, the heater is set
to the high heat setting, and all
Operation
initialize your fireplace for the
first time. This procedure is also
required every time there is a loss
of power to the remote control in
the fireplace (I.E. power failure,
breaker tripped, main power
switch is turned off).
Ensure that power is supplied 1.
through the main service
panel.
Access the manual controls,
2.
(remove glass doors or pull
grill down if applicable) pull
the right side steel curtain
to the outside of the unit (if
applicable).
Locate manual controls.
3.
Activate main power switch. 4.
Press and hold the on switch 5.
marked “ ” for five (5)
seconds (red indicator light
will flash).
Press the on button located
6.
on the remote control
transmitter.
This will synchronize the remote
control transmitter and receiver.
Remote Control Usage
The remote control operates the
fireplace levels sequentially. The
level is increased every time the
ON button on the transmitter is
ON
Button
Battery
Cover
OFF
Button
Battery
Figure 4