Dimplex DFB6016 - Manual (Page 11)

11
Operation
C. Flame Action Control
Turn the flame action control knob
to adjust the flame speed control
to the desired level.
D. Manual Selection Switch
operates the electric fireplace
manually. Pressing the switch up
(“ “ position) once turns on the
electric fireplace and activates
Level 1, twice activates Level 2,
three times activates Level 3.
Pressing the switch down (“
“ position) turns the electric
fireplace oFF.
Level 1 : The flame effect
is turned on and the first red
indicator light illuminates .
Level 2 : The flame effect
remains on, the heater is
activated to the low heat
setting, and the first and
second red indicator lights
illuminate .
Level 3 : The flame effect
remains on, the heater is set
to the high heat setting, and all
three red indicators illuminate .
Resetting the Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the
main on/off switch to off and
waiting five (5) minutes before
switching the unit back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call
Dimplex north America Limited
at 1-888-346-7539.
Remote Control
The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one of
2,178 independent frequencies
to prevent interference with other
units. The frequency designation
is indicated on the back of the
transmitter.
Remote Control Initialization/
Reprogramming
Follow steps 1 through 6 to