Dell 4161DS - Manual (Page 15)

Installation 15
To install the 0U switch mounting bracket (shipped as default):
1
Line up the holes of the mounting brackets with the screw holes in the switch.
2
Fasten the mounting bracket to the switch using the button head socket cap screws on
each side.
3
Mount the switch assembly to the rack by inserting the three mounting hooks on one side
of the bracket into square holes in the vertical rack.
4
Press down until the blue push button pops out and clicks.
Figure 2-1. OU Mounting Bracket Installation
To install the 1U four point switch mounting bracket:
1
Remove the screws on each side of the 1U four-point switch and set them aside to attach
to the front 1U bracket pieces later.
2
Line up the vent holes in the “long side” of the kit’s front brackets with the vent holes in
the switch.
3
Line up the screw holes in the bracket with the screw holes in the switch.
4
With a Phillips screwdriver, fasten the front mounting brackets to the switch using two
screws on each side.
5
Attach four cage nuts or clip nuts to the rack mounting flange of the rack cabinet’s front so
that the nut is positioned on the inside of the rack.