Denon AVR-686S User Manual

Page 46

Advanced Setup

ENGLISH

• The audio delay setting does not apply when playing in the EXT.

IN mode or in the analog input direct mode or stereo mode.

• By default, this menu is not displayed when no digital signals

are being input.

The surround mode used last for the three types of input signals
shown below is stored in the memory, and the signal is
automatically played with that surround mode the next time it is
input.
Note that the surround mode setting is also stored separately for
the different input sources.
q Analog and PCM 2-channel signals (STEREO)
w 2-channel signals in the Dolby Digital, DTS or another multi-

channel format (DOLBY PL

x Cinema)

e Multi-channel signals in the Dolby Digital, DTS or another multi-

channel format (DOLBY/DTS SURROUND)
Default settings are indicated in ( ).

Setting the Auto Surround Mode

Press the

CURSOR F

button to select the Auto

Surround mode, then press the

ENTER

CURSOR

button to switch the Ext. In Subwoofer Level

setting.

* A u t o S u r r . O N

OFF

• When watching a DVD or other video source, the picture on the

monitor may seem delayed with respect to the sound. In this
case, adjust the audio delay to delay the sound and synchronize
it with the picture.

• The audio delay setting is stored separately for each input

source.

Setting the Audio Delay

Press the

CURSOR F

button to set the delay

time, then press the

ENTER

CURSOR H

button to

switch the Auto Surround Mode setting.

With a movie source, for example, adjust so that the
movement of the actors’ lips is synchronized with the sound.

* A . D e l a y 0 m s

0ms

100ms

200ms

Set the method of playback of the analog input signal connected
to the EXT. IN terminal.

Setting the Ext. In Subwoofer Level

Press the

CURSOR F

button to select the ext. in

subwoofer channel level playback, then press the

ENTER

CURSOR H

button to switch the Power

Amp Assignment setting.

* E x t . I n S W + 1 5 d B

+0dB

+5dB

+10dB

+15dB

Make this setting to switch the power amplifier for the surround
back channel to ZONE2.

Setting the Power Amp Assignment

Press the

CURSOR F

button to select “S. Back”

or “ZONE2”, then press the

ENTER

CURSOR H

button if you want to start the settings over from the
beginning.

* P . A m p S . B a c k

S.Back

ZONE2

MAIN ZONE

Surround back

7.1ch system

ZONE2

5.1ch system

Power Amp

Assign.

ZONE2

–

2ch system

SPEAKER OUT

ENGLISH