Denon AVR-686S User Manual

Page 35

Advanced Operation

ENGLISH

Preset memory

Set the

MODE 1

switch to “AUDIO” or “VIDEO”.

Set the

MODE 2

switch to the component to be

registered.

Press the

ON/SOURCE

and

OFF

button at the

same time.

• The indicator starts flashing.

• DENON and other makes of components can be operated by

setting the preset memory.

• This remote control unit can be used to operate components of

other manufacturers without using the learning function by
registering the manufacturer of the component as shown in the
list of preset codes (

End of this manual).

• Operation is not possible for some models.

Set to the AUDIO side for the CD, TAPE or CDR/MD position,
and to the VIDEO side for the DVD/VDP, DBS/CABLE, VCR
or TV position.

• The signals for the pressed buttons are emitted while setting

the preset memory. To avoid accidental operation, cover the
remote control unit’s transmitting window while setting the
preset memory.

• Depending on the model and year of manufacture, this function

cannot be used for some models, even if they are of makes
listed in the list of preset codes.

• Some manufacturers use more than one type of remote control

code. Refer to the included list of preset codes to change the
number and verify correct operation.

• The preset memory can be set for one component only among

the following: CDR/MD, DVD/VDP and DBS/CABLE.

The preset codes are as follows upon shipment from the
factory and after resetting:
• TV, VCR .........................................HITACHI
• CD, TAPE.......................................DENON
• CDR/MD ........................................DENON (CDR)
• DVD/VDP .......................................DENON (DVD)
• DBS/CABLE...................................ABC (CABLE)

Referring to the included list of preset codes,
press the

NUMBER

buttons to input the preset

code (a 3-digit number) for the manufacturer of
the component whose signals you want to store
in the memory.

To store the codes of another component in the
memory, repeat steps 1 to 4.

Operating a component stored in the preset
memory

Set the

MODE 1

switch to “AUDIO” or “VIDEO”.

Set the

MODE 2

switch to the component you

want to operate.

Set to the AUDIO side for the CD, TAPE or CDR/MD position,
and to the VIDEO side for the DVD/VDP, DBS/CABLE, VCR
or TV position.

Operate the component.

For details, refer to the component’s operating instructions.
Some models cannot be operated with this remote control
unit.

ENGLISH