beautypg.com

Directed Electronics S660 User Manual

Page 21

background image

2

21

1

Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-

board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK wire can be directly

connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must

be used to change the polarity. (See

Finding the Wires You Need section of this guide.) Here are some common

colors of this wire:

■ Chevrolet and GMC trucks - Light blue or dark blue
■ Ford Trucks - Black/pink
■ Dodge Ram Trucks - Orange/black or black/orange

N

NO

OTTEE!! A 1-amp diode must be installed in line on the factory wire between the wait-to-start

indicator and the ECM. (See the following diagram for details.)

This wire provides a second unlock output for progressive locks. Refer to document 1041—

Door Locking System

Wiring Guide for specific applications.

H

H2

2//6

6 LLIIG

GH

HTT B

BLLU

UEE ((--)) 2

20

00

0m

mA

A 2

2n

nd

d u

un

nllo

occkk o

ou

uttp

pu

utt

H

H2

2//5

5 W

WH

HIITTEE//B

BLLA

ACCK

K ((--)) d

diieesseell w

waaiitt--tto

o--ssttaarrtt b

bu

ullb

b iin

np

pu

utt