Directed Electronics S660 User Manual
Page 19
1
19
9
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant
12V supply to the ignition switch.
N
NO
OTTEE:: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A
fuse in the harness for this purpose. This fuse protects the module itself.
When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the red/white wire will
supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or
other relay-driven function.
IIM
MP
PO
OR
RTTA
AN
NTT!! Never use this wire to drive anything but a relay or a low-current input! The tran-
sistorized output can only supply 200 mA of current. Connecting directly to a solenoid, motor,
or other high-current device will cause it to fail.
H
H1
1//1
12
2 R
REED
D//W
WH
HIITTEE cch
haan
nn
neell 2
2,, 2
20
00
0m
mA
A ((--)) o
ou
uttp
pu
utt
H
H1
1//1
11
1 R
REED
D ((+
+))1
12
2V
V cco
on
nssttaan
ntt p
po
ow
weerr iin
np
pu
utt