Directed Electronics S660 - Manual (Page 16)

1 16 6
As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper under
the sliding door is moved to the opposite position (see Internal Programming Jumper section of this guide), this
wire supplies a (-) 200 mA output. This is suitable for driving (-) light control wires in Toyota, Lexus, BMW, some
Mitsubishi, some Mazda, and other model cars.
((+ +)) P Po ossiittiivvee LLiig gh htt FFllaassh h O Ou uttp pu utt
((--)) LLiig gh htt FFllaassh h O Ou uttp pu utt
N NO OTTEE:: For parking light circuits that draw 10 amps or more, the internal jumper must be
switched to a (-) light flash output. (See the Internal Programming Jumper section of this
guide.) P
P//N N 8 86 61 17 7 or a standard automotive SPDT relay must be used on the H1/2 light flash
output harness wire.
H H1 1//2 2 W WH HIITTEE ((+ +//--)) sseelleeccttaab bllee lliig gh htt ffllaassh h o ou uttp pu utt