Dixon Zeeter 16246-0803 - Manual (Page 14)

ZEETER HL 30”
CHASSIS: 11 gauge welded channel frame
BODY: All body parts made of rotational molded polyethylene.
Front body contains access panel for battery service.
MOWER DECK: 11 GA stamped steel construction. Single 30” cut blade.
Cut height approximately 1-1/2”- 4” via 7-position lift
handle.
BLADE DRIVE: Mechanical; hand lever engagement
TRANSMISSION: Each rear wheel is independently driven by a Hydro Gear
EZT self contained hydrostatic drive.
ENGINE: 11 HP Briggs & Stratton I/C, 4-cycle, single cylinder, air-
cooled, gasoline, vertical shaft, aluminum head and block,
cast iron sleeve, AVS balanced
STARTING SYSTEM: Electric by key switch operation with safety interlocks on
parking brake and blade drive.
TIRES: Front 9 x 3.50-4 Turf Tread
Rear 16 x 6.50-8 Turf Tread
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-14 PSI
CAPACITIES: Fuel 1.8 gallon
Engine 1.25 quarts oil
DIMENSIONS: Width 32.5” outside rear wheel measurement
Width 38” overall width of deck with deflector
Height 32” to top edge of seat
Length 67” hitch tab to front
Weight 393 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
14
SPECIFICATIONS