Collegamento elettrico, Electrical connection, Warning: this appliance must be earthed – ZANKER GS 105 User Manual

Page 16: Important

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Green and Yellow

to Earth

13 amp
Fuse

Blue to
Neutral

Brown

to Live

Cord
Clamp

COLLEGAMENTO ELETTRICO

Controllare che la tensione dell'impianto elettrico corrisponda a quella indicata sullo

targhetta caratteristiche posta sul loto sinistro in basso nella parte interna dello scom

parto congelatore.

Se la presa a muro è priva di contatto a terra, o se la spina non è adatta al vostro

impianto vi consigliamo di rivolgervi od un elettricista speciolizzato.

Non impiegare adattatori o derivatori che potrebbero causare riscaldamenti e bru

ciature.

ELECTRICAL CONNECTION

Check that the main voltage corresponds to that indicated on the rating plate in the

lower left side inside the freezer compartment.

If the wall socket does not have on earth terminal, or if the plug does not fit info the

socket, it is advisable to consult a qualified electrician. Do not use multiple plugs or

adapters as they could cause heating and burning.

WARNING: THIS APPLIANCE MUST BE EARTHED

If this appliance is fitted with a non rewirable plug for which your socket is unsuitable,

the plug should be cut off and an appropriate plug fitted. The removed plug must be

disposed of Insertion of the plug into o 13 Amp socket is likely to cause an electrical

hazord When a nonrewirable plug ora rewirable 13 Amp (BS1363) plug is used it

must befitted with a 13 Amp ASIA approved (BSl 362) fuse. If any other type of plug

is used it must be protected by a 15 Amp fuse either in the plug or at the distribution

board

IMPORTANT:

THE WIRES IN THE MAIN LEADS ARE COLOURED IN ACCORDANCE WITH

THE FOLLOWING CODE;
GREEN AND YELLOW • EARTH BLUE - NEUTRAL

BROWN - LIVE

As the colours of the wires in the main lead of your appliance may not correspond

with the coloured marking identifying the terminals in your plug, proceed as follows.

CONNECT GREEN & YELLOW coloured wire to plug terminal marked letter "E" or

earth symbol -4^ or coloured green or green & yellow,

CONNECT BLUE coloured wire to plug terminal marked letter "N" or coloured black.

CONNECT BROWN coloured wire to plug terminal marked letter "L" or coloured

red.