Setting the timer, Preparation, To check the specified time and source – Aiwa CX-NA22 User Manual

Page 17: To cancel timer standby mode temporarily, Using the unit while the timer is set, Timer recording

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING THE TIMER

The unit can be turned on at a specified time every day with the

built-in timer.

4 Within 4 seconds, seiect the duration for the

timer-activated period with the ◄◄ DOWN or I

UP button.

i\/i I

I I

I I

The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
• If this step is not compieted within 4 seconds, repeat from

step 1.

5 Prepare the source.

To listen to a CD, ioad the disc to be piayed first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.

6 Press the POWER button to turn the unit off after

adjusting the voiume and tone.

s
p

Preparation
Make sure the ciock is set correctly.

Use the remote control.

1 Press the TIMER button while pressing the SHIFT

button once to display ©, and press the II SET
button within 4 seconds.

is dispiayed, and the hour fiashes.

i\/i

I I /

I I I I I \

If you press the

SET button after 4 seconds, another

operation may start.

2 Designate the hour of the timer-on time by

pressing the ◄◄ DOWN or ►► UP button, and
press the 11 SET button. Repeat to designate the
minute of the timer-on time.

I i\/i I

j. I I C

I I

After you designate the timer-on time, one of the source name
flashes on the display for 4 seconds.

3 Within 4 seconds, press the FUNCTION button

repeatedly to select a source.

The selected source name flashes for 4 seconds.
• If this step is not completed within 4 seconds, repeat from

step 1.

■

• If the TUNER button is pressed, the band cannot be selected

in this step.

When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 16 when the power is
turned off with the volume level set to 17 or more.

To check the specified time and source

Press the TIMER button while pressing the SHIFT button. The

timer-on time, the selected source name and the duration for
the timer-activated period are displayed for 4 seconds.

To cancel timer standby mode temporarily

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.

Press the TIMER button repeatedly while pressing the SHIFT
button so that © flashes on the display, and press the

SET button within 4 seconds. Ftepeat the steps shown above
from step 2 and insert the tape to be recorded into deck 2 after
step 5.

' Timer playback and timer recording will not begin unless the

power is turned off.

' Connected equipment cannot be turned on and off by the built-

in timer of this unit. Use an external timer.

ENGLISH

1 6