Denon AVR-787 - Manual (Page 57)

ENGLISH
54
ENGLISH
Advanced Setup – Part 1
Setting the Setup Lock
This sets whether or not to lock the system setup settings so that
they cannot be changed.
Press D D H H to select “Setup Lock”, then press ENTER .
Press F F to select “ON”, then press ENTER .
• When the setup lock function is activated, the settings listed below
cannot be changed, and “SETUP LOCKED” is displayed when
related buttons are operated.
• System setup settings
• Surround parameter settings
• Tone control settings
• Channel level settings (including test tones)
• To unlock, press SYSTEM SETUP again and display the “Setup Lock”
screen, then select “OFF” and press ENTER.
1
2
1
2
Advanced Setup – Part 2
• If the “Auto Setup” procedure has already been performed, there is
no need to make this setting.
• Perform this setting if you wish to make the settings for your
speaker systems manually.
Speaker Setup
Setting the Speaker Configuration
Automatically set the output component and properties for the
various channels according to the combination of speakers to be
actually used for surround playback.
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
ENTER
D H F G
[TEST TONE]
D H F G
ENTER
F G, ENTER
D H
Press D D H H to select “Speaker Setup”, then press
ENTER .
Press D D H H to select “Speaker Config.”, then press
ENTER .
Press D D H H to select the speaker, then press F F G G to set.
Large:
Select this when using large speakers with ample low frequency
reproduction capabilities.
Small:
Select this when using small speakers without ample low frequency
reproduction capabilities.
Yes / No:
Select “Yes” when a subwoofer is connected, “No” when no
subwoofer is connected.
None:
Select this when no speaker is connected.
2sp / 1sp:
Select the number of surround back speakers.
1
2
3