English – Denon AVR-787 User Manual

Page 21

Connecting Other Sources

ENGLISH

Connecting the XM terminal

• AVR-787 is the XM Ready® receiver. You can receive XM® Satellite Radio by connecting to the XM

Passport System (sold separately) and subscribing to the XM service.

• Plug the XM Passport System into XM terminal on the rear panel.
• Position the XM Passport System near a south-facing window to receive the best signal.

For details, see “XM Satellite Radio” (

page 34, 35).

When making connections, also refer to the operating instructions of the XM Passport System.

NOTE:
• Keep the power supply cord unplugged until the XM Passport System connection has been completed.

AUX OUT

XM Passport System

NOTE:
• Do not connect two FM antennas

simultaneously.

• Even if an external AM antenna is used, do

not disconnect the AM loop antenna.

• Make sure the AM loop antenna lead

terminals do not touch metal parts of the
panel.

Note to CATV system installer:
This reminder is provided to call the CATV
system installer’s attention to Article 820-40 of
the NEC which provides guidelines for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the
grounding system of the building, as close to
the point of cable entry as practical.

Connecting the iPod

iPod

ASD-1R

AUDIO OUT

S-VIDEO OUT

When using an iPod, you must connect the Control Dock for iPod (ASD-1R, sold separately) and the DOCK
CONTROL jack on the AVR-787 with a mini-jack and assign the iPod to any AUDIO and/or S-VIDEO
terminal(s).
The diagram below shows an example of connections for when the iPod is assigned to the DVD/VDP
terminal.

For instructions on assigning the iPod to a specific terminal, see “Setting the iPod Assignment” (
page 48).
For instructions on playing the iPod, see “Playing the iPod” (

page 37).

• The optional standard Control Dock for iPod is DENON ASD-1R sold separately.