A&D Journal Printer AD-8118A - Manual (Page 20)

Operating the Control I/O
Inputs
Code
Print
command*
Paper feed
command
Addition print
command *
Subtotal
printing
command
Grand total
printing
command
Delete
command
Cumulative
total delete
command
Input for
disable
printing time
The value is printed on the left side of the paper when
addition printing is done. This value is stored with the
we^ht value and can be retrieved by code as well.
This code is not printed if the value is "00," only
numbers from 01 to 99 can be used.
When this input is negative low (short), the first data
input within 3 seconds is printed.
This command advances the paper one line, negative
low(short).
When this input is negative low(short), the first data
input within 3 seconds is added and printed.
This command prints the subtotal value and clears after
printing.
This command prints the grand total value and does not
clear the subtotal or grand total after printing.
This command deletes the last added data from the
cumulative total value and then prints the message
"^CANCEL". It is unable to perform this command if
there is no cumulative total value.
This command deletes the cumulative total value and
then prints the message "¥CLEAR". It is unable to
perform this command if there is no cumulative total
value.
Time printing is disabled while this input is ON. Once
OFF, the time printing is preformed once more on the
next printing time. In cumulative total printing, time
printing is preformed regardless of the input.
This output is turned ON when the data buffer exceeds
75 lines.
Outputs
Busy
Printing This output is turned ON when the unit is printing,
announcement Control inputs are not accepted during this time.
Therefore, enter the control input when this output is
OFF.
owners-AD-8118A-v.3.a Page 19