Audiovox CTX5000 - Manual (Page 9)

Last Number Review
Press I RCL I , key [^then fo] again, the last number
in the display returns.
Display Own Telephone Number
You can see your own telephone number on the
readout. Press | RCL I, key then again.
Repertory Memory Scroll
This feature will be useful in finding a certain
telephone number by scrolling the repertory memory
from one of the designated starting addresses.
1. Press i RCL I, key then [#]
[~X] is the digit to assign the starting address as
follows.
X Starting address
0 01
1 11
2 21
8 81
9 91
2. Press [#] or Q
[#]' Scroll upward (with roll back to 01)
Q: Scroll downward (with roll up to 99)
Memory address and the last seven digits of the
stored number will be displa
3^ed on the readout
as follows.
Example: ¡3 jl |-| 11 2 j 3 1 4 [ 5 | 6 [ f|
Address No Tel! No" ^
Note: In this scroll feature, any vacant memory
address will be skipped.
Automatic Storing into A Vacant Memory
Address
This feature allows automatic storing into a
vacant repertory memory address. This eliminates the
possibility problem of writing over a previously
stored number.
1. Enter a telephone number.
2. Press [ST^
0:
From 01 to 10
S:
From 11 to 20
0:
From 21 to 30
0:
From 81 to 90
From 91 to 99
ffl:
From 01 to 99
3, Enter the memory address in which you want to
store a number.
to
4. Press [5]
The the memory address and the last seven
digits of the stored telephone number will be
displayed on the readout as follows.
Example: |Y1 r["Tl I 2 | 3 l 4 l 5 l 6 | f |
If there is no vacant address in the assigned
area, telephone number will not be stored in the
memory.
To Lock the Unit
Press
I
FUNCl, then the numeral
|T]
(LOCK).
The
I
LOCl^ indicator lights. The unit will remain
locked until unlocked.
Automatic Lock(NAM OPTION)
If you request it, your NAM can be changed and
your unit will automatically go into lock condition
when your ignition is turned “off”. When the key is
turned “on”, the unlock code is required to operate
the phone.
To Unlock the Unit
Enter the three digit unlock code. The indicator will
go out when three digits are the same as the
resistered code in NAM.
Backlighting Control
LCD display and the keypad will be backlit
automatically after the Switch On.
If needed, backlighting can be turned off pressing
I
RCL
I
, key then .
17