Audiovox CTX5000 - Manual (Page 14)

I Link 3 [will appear in display.
Note: If a set of linked numbers has been stored
in memory address 91 through 99, press
I RCL I then memory address (91 through 99),
then ! SND I,
[ Link 1 [will appear in display, and the first
linked number will be called.
Following procedures are the same as step 7 and
onward of the example above.
SCRATCH-PAD DIALING
This feature permits you, while engaged in a
conversation, to enter a number to be re-dialed (or
store a number in memory).
SCRATCH PAD DIALING
WITHOUT KEYING TONES
This feature permits you to activate scratch-pad
memory without annoying key tones over the
circuit.
1- Press I FUNC |, | MUTE | then enter a telephone
number. The Microphone circuit will remain
active, but the tones will not be heard.
2. If necessary, press | STO |, then enter the memory
address.
3. To exit the Scratch pad Mode, press | FUNC |,
I MUT e I again.
CALL TIME DISPLAY
This feature automatically records the elapsed time
per conversation.
The talk time of the last call, cumulative talk time,
and the number of calls can be displayed on the
readout.
The timers can also be cleared if necessary.
With beep tones you can be notified of the
approximate talk time (NAM Option).
To Display the Talk Time of the Last
Call
1- Press I RCL I, key F^then [TJ.
The talk time of the last call will be displayed
on the readout for 5 seconds.
26
While in a conversation, the talk time of a call in
progress will be displayed, and updated each
second.
The display format is as follows.
11m251---1 min and 25 sec
To Display the Cumulative Talk Time
1. Press I RCL I, key then [ 2].
The cumulative talk time will be displayed on
the readout in minute format for 5 seconds.
1 18m I- - 18 min
To Display the Number of Calls
1- Press [ RCL I, key then .
The number of calls will be displayed on the
readout for 5 seconds.
The display format is as follows,
I 86c |- ■ ■ Received or placed 86 calls.
To Clear the Timer
1- Press I CLR I , then enter the three digit code
specially assigned.(NAM Option)
2. Press i STO I , key then [T].
The timers will be cleared, and the count for the
cumulative talk time and the number of calls will
start from zero.
One Minute Beep (NAM OPTION)
During conversation, you can be notified of talk
time roughly by tones for the first five
minutes.(every one minute you can hear a short
monotone signal).
A / B SYSTEM SELECTION
This feature permits you to select the system you
wish to use. The system that you are registered
with is the preferred system, and your home system.
1. Standard Mode
When you turn the unit on, the unit remembers
the last position of the A / B selector, and will
start to scan the radio frequency channel of that
selection.
27