Assembly instructions – Bolens 19967-1 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BOLT lYi
ELLEVILLE
ASHER (Z)
HOUSING
\
SKID SHOE HEX NUT (AA)
FIGURE 2
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
(1) Adjustable wrench
(1)
9/16" Open end or box wrench
(1)
1/2" Open end or box wrench
(1) 7/16" Open end or box wrench
(1) 3/4" Open or box wrench
(1)
11/16" Open end or box wrench
(1) Drift or punch
(1) Pairofpliars
1. Assemble the skid shoes to each side of snow
_ thrower housing. Place head of carriage bolt (Y)
to the inside of housing and fasten with be)leville
washer (Z) and hex nut (AA). Only make finger
tight at this time. See figure 2.
DRIFT CUTTER
CARRIAGE BOLT IV)
HEX NUT IX)
2.
Assemble the drift cutters to each side of snow
thrower housing. Place head of carriage bolt (V)
to the inside of housing and fasten with lock
washer (W) and hex nut (X). A 1/2" wrench is
required. See figure 3.
FIGURES
REASE THIS
REA
HEX LOCK NUTS (K)
4.
Apply a little grease to the lip of the chute
opening before assembly of chute. See figure 4.
Set the chute assembly in place on the chute
opening of snow thrower housing. Secure in place
with three flange keepers (J) and six hex lock
nuts (K). A 7/16" wrench is required. See figure 4.
FIGURE 4