Bolens 19967-1 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 20
3. Raise the tractor undercarriage to highest position.
4. Roll the tractor over the rear of snow thrower.
Slip the universal drive shaft ends together.
Raise the rear end of snow thrower up to align
hanger brackets with holes in back of tractor
transaxle. Use clevis pins, washers and hair pins
from tractor 3 point hitch. After installing clevis
pins, tighten bolts on hanger brackets using two
9/16" open end wrenches. See figure 20.
7.
Remove cotter pin and clevis pin from front
hanger brackets. Swing brackets open. See figure
21
.
FIGURE 21
Lower tractor under carriage and install hanging
brackets to front cross shaft. See figure 22. Put
clevis pin through small hole on hanging brackets
to secure brackets around cross shaft. Insert hair
pin into hole in clevis pin..to hold pin in position.
11