Please seek assistance for this procedure, I nsta 11 at! o n i ns tru ctl o n s – Bryant 463AAC008BA User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I nsta 11 at! o n I ns tru ctl o n s
2. Preparation to remove the
Air Conditioner Slide-Out Chassis
(Mode) 4S3AAC005BA)
A Tilt the unit on its back {Fig 1) be careful not
to damage the drain on the back
B Locate the finger indents on the underside of
the interior air inlet griHe(F/ig 2)
C Lift the air inlet gritle{fully open) until it
disengages from the top edge of the front
panel{F/g 2)
D- Remove the Philips screw located at the lower
(right hand) corner of the front grille and the Philips
screws from both sides of the cabinet {Fig 3)
E Grasp the lower front comer of the front panel,
pulling (gently) outward and upward Repeat
this step on the 3 remaining comers {Fig 4)
F Grasp the pull handle at the front of the
slide-out chassis and carefully slide the air
conditioner out of the cabinet {Fig 4)
3. Preparation to Remove the
Air Conditioner Slide-Out Chassis
(Mode) 463AAC008BA)
A Remove the (2) Philips screws on each side of
the cabinet The set of screws closest to the
front of the unit, secure the front panel to the
cabinet The set of screws closest to the rear of
the unit, secure the cabinet to the chassis
See {Fig 5)
B Remove the front panel assembly from the
cabinet by gently pulling it
C Grasp the pull pane) at the front of the
slide-out chassis and carefully slide the
air conditioner out of the cabinet {Fig 6)
Fig 1
Fig 2
NOTE* Screws must be reinstalled upon
completion of the window installation to secure
slide-out chassis.
Please seek assistance for this procedure