Caution a, Installation instructions – Bryant 463AAC008BA User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions
B Measure the inside window sili width and find the
canteras shown in (Fig 14) Measure 9 1/4” from the
center line on each side and mark these points Align
the V-slot in each bracket on these marks and mount
the brackets to the sill using 3/4** screws provided.
Brackets should be perpendicular to the inside window
sill. See (Fig 14)
C For proper condensation run-off it will be necessary
to adjust the angle/pitch of the window brackets This is
accomplished by adjusting the distance of the leveling
screw on the outer wall The maximum angle/pitch
should not exceed more than 3/16" See {Fig 16)
D Cut the first foam sealing strip to fit the
underside of the bottom window sash Remove
the peel-off backing on the foam and attach it
to this sash See (Fig 12)
CAUTION A
Use a solid piece of wood to provide stability This
will be required when sills are extra deep
See {Fig 15)
—
10