Bulldog Security DELUXE 500 - Manual (Page 9)

REMOTE START OPERATION OPERATION
“t^-00 Time Monitor "^00 Alert Alarm
You have set the morning
call alarm.
a 10 Count Down (Parking) Timer save Power Save Mode
Reminder when your time is
up for parlo'ng.
Vibration Mode
Remote control vibrate when
the system Is triggered.
Low Battery
You must replace the battery
in the remote control.
Saves the battery power.
Button Lock
Disable the transmission
functions tempoterlly.
Q
M.PROGRAMMING THE LCD REMOTE TRANSMITTER:
Transmitter
Button
Description Operaflon
F [1 second) LCD screen lamp turns
on for 5 seconds. Press and hold for 1 sec.
1 melody sound to confirm enters.
F (3 seconds] Timer Programming Mode. Press and hold for 3 sec.
2-melody sounds to confirm enter.
F (5 seconds] Power Save Mode Press and hold for 5 sec.
1 Melody sound to conf rm enters.
F-F-F □ear the Flash Icon and
Melody Sound on the LCD
Screen Transmitter Press within 3 sec.
F-B(2-sec.] Button Lock (1) enable/dlsable Press within 3 sec.
F - 3 (2-sec.) Melody / Vibration (^) Mode Press within 3 sec.
K. ACTIVE DISARMING - UNLOCK A DISARM:
1. Press the Q button on the transmitter.
2. The siren will chirp (2) times and rarMng lights will
flash (2) times and then remain "ON" for 30 seconds
indicating that the security system is now disarmed. The
vehicle's doors will unlock and dome light will turn "ON"
for 30 seconds upon disarming when interfaced with the
secunty system.
TWO STEPS DOOR UNLOCK:
driver's door only when
button a second time within
LOCK; This feature will Independently unlock the
disarming the security system. Pressing the d
Ithin 3 seconds will unlock the remaining doors.
AUTOMATIC RE-ARH; If this feature Is selected, the security system will
automatically re-arm Itself In 60 seconds alter disarming with the remote
transmitter. Automatic rearm will cancel if any door is opened before the
60 second timer has elapsed.
L. DISARMING WITHOUT A TRANSMITTER
OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:
The override function may be used if the remote transmitter is lost or
inoperative.
1. Enter the vehicle and turn the ignition switch to "ON" position. (Alarm
will sound.)
2. Within 10 seconds press and release the valet switch.
The alarm will stop sounding and enter the disarm mode. You can now
start and operate the vehicle normally with the ignition key.
iws yoi
eliminating the need to hand your transm'ittér to
I alarm functions,
I attendants or
M. VALET MODE:
The valet switch allows you to temp
parking i
garage mechanics. When the system is in "Valet Mode*^ all alarm function
and remote starter functions are bypassed, however the remote panic
feature and remote door locks will remain operational. Tb use the "Valet
Mode", the system must first be disarmed either by using your remote
transmitter, or by operating the Manual override sequence.
20