S. trunk release (channel 3) output, T. channel 4 timer control output, U. channel 5 hmer control output – Bulldog Security DELUXE 500 User Manual

Page 12: V. channel 6 timer control output, Exit tho tlnior start, G. interior temperature monitor, H. to turn off the remote starts, T. channel 4 timer output, U. channel 5 timer output, V. channel 6 timer output -13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION

REMOTE START OPERATION

S. TRUNK RELEASE (CHANNEL 3) OUTPUT.

Press snd hold the ^ button on the transmitter for two sec

onds to remote control the tnink release or other connected
electronic devices.

T. CHANNEL 4 TIMER CONTROL OUTPUT

Press the transmitters fl

(4)

and ^

(4) buttons

at the

same time to active the

Channel 4 funcnon.

Channel 4 is user-programmable

timer output. You may program the bullt-ln timer to send a ground signal
for any time duration mom f second to 120 seconds. For Instance,

this timer output may be used to turn on the

headlights,

power

windows or sunroof.

[Factniy defaults setting at momentary

output.)

U. CHANNEL 5 HMER CONTROL OUTPUT

Press the transmitters 3 [n and ^ (5) buttons at the same dme to

active the

Channel 5

ftmctlon. Channel 5 Is user-programmable timer

output. You may program the built-in timer to send a ground
signal for any time duration from 1 second to 12D seconds.

For instance, this timer output may be used to turn on the

headlights,

power

windows

sunroof.

(Factory detaults

setting at monMntary output.)

V. CHANNEL 6 TIMER CONTROL OUTPUT

Press the transmitters

(6)

it and

(6) ^buttons

at the same time to active

Channel 6 function. Channel 6 is user-programmable timer output. Ybu may
program the bullt-ln timer to send a ground signal for any time

dur^on from 1 second bo 120 seconw. For Instance, this timer

output may be used to turn on the headlights, power windows

or sunroof.

(Factory defbuRs sotting at momontary output)

Exit tho tlnior start:

Timer start can be esdted manually as fbllovirs:

Make sure the engine is not running in remote start mode.

Turn the ignition Hey

ON.

The LED and parking lights will flash (4) times.

The hom chirps (4) times.

Press the ^

button

twice to remote start the vehicle. As soon as the

vehicle Is running and the parking light have turned

or are flashing.

2.Immediately d»res5 the ^

button,

then press and hold the %

button

for 2 seconds. The parking lights will flash (4) times. The siren or hom
chirps (4) times. The vehicle Is no longer programmed to start automatically.

G. INTERIOR TEMPERATURE MONITOR

You can monitor through the LCD screen, the present interior

temperature of the passenger compartment before cooling or
heating your vehicle. Press the transceiver

F button

first,

within 3 seconds press the ^ (h

button;

the interior temp

erature will be shown on the IXD soeen. This reading may be
higher than actual ambient temperature due to the greenhouse
elrect and Is relative only the Inside vehicle temperature.

H. TO TURN OFF THE REMOTE STARTS

When the engine Is running [In remote start mode), to shut the
engine off: Press the ^

button

twice on the remote transmitter.

Move the optional remote start enable toggle switch to the

"OFF’'

position. (If Installed) Press the brake pedal. Release the

emergency brake, (for Standard Ttansmlssfon Vehicle} The
vehicle win shut down and turn off the parking lights to Indicate
engine has stopped.