Audiovox MVX501 - Manual (Page 8)

Do not recharge or “top-off’ the battery pack by charging
for short periods of time to avoid shortening the battery
life. It is recommended to charge the battery after the bat­
tery is discharged completely.
The product that you have purchased contains a recharge­
able Battery. The Battery is recyclable. At the end of its
/ X useful life, under various state and local laws,
^ illegal to dispose of this Battery into
A-W the municipal waste stream. Check with your
\| local solid waste officials for details in your
area for recycling options or proper disposal.
Power Management
Talk & Stand-By Times
Battery Talk-Time Stand-By Time Weight
800 mAH NICAD
BTR405
80 Minutes 12 Hours 7.7 oz.
1200mAH NiMH
BTE405
120 Minutes 20 Hours 8.1 oz.
800 mAH NiMH
BTM405 80 Minutes 12 Hours 7.7 oz.
Please note all times are approximate.
BATTERY LEVEL INDICATION
To display your battery level, press (z5). To clear
the display, press (c^.
Note that the battery level indication may be affected by vari­
ables such as temperature, battery age, and charging condi­
tions.
Talk & Stand-by times can vary and are dependent upon the
coverage of the network and how you use your phone.
LOW BATTERY WARNING
When “Lo ~ bfitt” flashes every second and an alarm tone
sounds, there are only a few minutes left for call processing. If
usage continues, "L o ~ bRt b ” flashes more frequently. A few
moments later, your call is terminated and your phone is automati­
cally turned off.
12
BASIC OPERATION
TURNING YOUR PHONE ON AND OFF
Press and hold <^s) to turn on your phone. Your own tele­
phone number will be momentarily displayed.
Note: When “NO SVC” (No Service) is displayed, you can­
not place or receive calls as the “Cellular System”
is not available.
To turn off your phone, press and hold again.
Backlighting
When you press any key, the backlighting for display and
keypad turns on to provide easier operation of your phone.
It will go out 8 seconds after the last key press.
Antenna Position
You can receive calls while the antenna is down. However,
for optimum performance and signal strength or while oper­
ating in poor signal areas, please extend your antenna fully.
Note: The antenna can be used in its fully extended or
fully retracted position only.
Display Own Telephone Number
Press ( f ^, (#D,CiZ)-
To clear the display, press (@).
Display Own System ID
Press To clear the display, press @)-
PLACING CALLS
1. Enter the telephone number.
2. Press (S^.
The IN USE indicator will light.
3. When you finish talking, press
13