Audiovox MVX501 - Manual (Page 14)

EXTENDED FEATURES AND FUNCTIONS
CALL RESTRICTION
In the call restriction mode, only specific keys are effective
to prevent unauthorized operation of your phone. Only the
following keys are operative to place a call.
1) Any combination of numbers 1 and 2 for a call:
• @ + (1, 2, 11, 12, 21, 22) + (@)
2) Emergency Calls:
• ( r ^ + 2 + 9 +
• 9 + 1 + 1 +
• 0 + 0 + 0 +
• 1 + 1 + 9 +
3) One Touch Emergency Call:
• Holding (i3 for 2 seconds.
Note: You can receive a call even if your phone is in the
call restriction mode.
To Activate Call Restriction
1. Press ( f ^,
2. Enter the 3-digit Call Restriction code.
Note: Please contact your authorized Audiovox dealer to
check the initial Call Restriction code.
“ l TI?” will be displayed to indicate that call restriction is in effect.
Note: The call restriction is effective until it is deacti­
vated. When your phone is powered up, will
be displayed. (“L oc ' d” will be displayed if your
phone is locked.)
To Exit Call Restriction Mode:
While “CP” is displayed, enter the 3-digit Call Restriction
code.
To Change the Call Restriction Code
1. Press ( f ^, (g^.
“CP P____ ” will be displayed.
Enter the current 3-digit Call Restriction code.
2.
■i” will be displayed.
3. Enter a new 3-digit Call Restriction code except 911
000, and 119.
4. Press (¿3)-
24
CAUTION: Keep the record of new code in a safe place!
Note: If you enter a wrong code in step 2, your phone
returns to standby mode.
KEYPAD (DTMF) TONES
Dual Tone Multi-Frequency (DTMF), or “Keypad Tone” sig­
nals can be transmitted during a call by entering digits on
the keypad or recalling numbers from the memory. By send­
ing the DTMF signals, you can access special services such
as voice mail and answering machines that require long du­
ration tone.
Keypad (DTMF) Tones Duration Selection
To toggle the Long Tone and Short Tone for the time dura­
tion of DTMF tones, press
Keypad (DTMF) Tones Mute during conversation
To mute the keypad (DTMF) tone, press @), (з^ during
conversation.
To enable the keypad (DTMF) tones, press <5^, (з^ again
during conversation.
Sending DTMF Tones During a Call
From the Keypad:
1. During a call, press any key on the keypad.
From the Memory:
1. During a call, press @), ($3.
2. Enter a 2-digit memory location (01-28).
TIMER AND COUNTER FUNCTIONS
Elapsed Time Display
You can display the elapsed time of the call or last call while
not in use.
1. Press ( fnc ). <5^. (0^.
“R iP XX-xx” will be displayed. (XX: Minutes, xx: Seconds)
2. Press to exit this mote.
Note: The time count will automatically reset to 00:00
after 99 minutes and 59 seconds.
25