Audiovox MVX501 - Manual (Page 19)

Deleting a Message Individually
1. Press (c^ momentarily. “L L /?” will flash in the display.
2. If you do not wish to delete the message, press Or
to execute the deletion of the message, press @).
‘'CLEFtrEd” will be displayed momentarily.
Deleting all the Messages
1. Press and hold for 2 seconds.
“RL L LL R” will flash in the display.
2. If you do not wish to delete all the messages, press
Or to execute the deletion of all the messages, press @).
"Ri L Et-E Rr Eo'” will be displayed momentarily.
Storing a Digit Message of Call Back Number and Caller
ID into Phone Number Memory
1. Press .
2. Then enter XY . (XY is a memory number of 01 to 25.)
Or to automatically store a digit message at an unused
memory location, press . The stored memory
number will be displayed for one second.
Notes: • Only digit messages can be stored.
• UNA (Number not available) and RES (Num­
ber Restricted) or Short Message will not be
stored.
Caller ID
When your phone receives a call, the caller’s phone number
will flash in the display. If you are in a conversation and
another call is attempted, the caller’s phone number will be
displayed in Call Waiting. The caller’s phone number will
be stored in the memory.
To answer the call, press any key except (@) and (™^.
If you do not answer the call, the number of unanswered
call will be displayed and the caller’s phone number will be
stored in the memory.
34
Voice Mail Access Number
In the following cases, you can place a call to your Voice
Mail Access number in Memory number 30 by pressing (smS)
only.
• At Voice Mail Notification
• At Short Message “nr 5” display during Message Review
mode
Note: It is required to store your Voice Mail Access num­
ber in Memory number 30 in advance by usual
memory storing operation.
Message Beep Alert
Your phone will beep when receiving Message services:
• Short Message........................Repeat of single Beep
• Voice Mail Number/
Voice Mail Notification....... Repeat of two Beeps
• Call Back Number...................Repeat of three Beeps
• Flash with Info........................ Repeat of three Beeps
Note: When Message Display Mode is Off, the above
Beep Alert will not be repeated.
Message Beep Alert Tone Level Control
You can adjust Beep Alert tone level to seven levels while
not in use.
1. Press
The current Beep Alert Tone will be heard and the level
will be displayed.
2. Press C a ) or (5j) according to your desired tone level.
3. To clear the display, press <@).
Message Beep On/Off Selection
Message Beep ON mode is preset at the factory.
1. To toggle Message Beep On/Off mode, press
(7^ .
“RS hEEP oE”or“RS bEEP on” will be dis­
played.
2. To clear the display, press •
When Message Beep Alert Mode is Off, Message Beep
Alert will not sound even if your phone receives Message
services.
When Message Beep Alert Mode is Off, “MS bEEP oP”
will be displayed upon power up. To clear the display, press (^.
35