Audiovox MVX-500 - Manual (Page 15)

Note: The number linked in steps 1 through 5 can
also be stored in secret memory as stated in the
“Secret Memory”.
1. When a set of linked numbers which in­
cludes a secret number has been stored in
memory address 91 through 99, enter the
three-digit security code, press iflCL ,
memory address {91 through 99), and then
to place the call. appear
on the readout, and the first linked number
will be called as shown in step 6 above.
If the secret number is not included in the
linked number, you need not enter the
three-digit security code in the above op­
eration.
2. To complete the call, continue operations
as shown in the steps 7 and 8.
SCRATCH PAD DIALING
This feature permits you to enter a number to be
redialed (or store a number in memory) while en­
gaged in a conversation.
SCRATCH PAD DIALING
WITHOUT KEYING TONES
This feature permits you to activate scratch-pad
memory without annoying key tones over the circuit.
1. Press PNC! , then key , then enter a phone
number. WWMI will be displayed for 5 seconds.
2
.
3.
The Microphone circuit will remain active, but
the tones will not be heard.
If necessary, press iST 0 i , then enter the memory
address.
To exit the Scratch-pad Mode, press , then
key ^ again.
CALL TIME DISPLAY
This feature automatically records the elapsed time
per conversation. The talk time of the last call,
cumulative talk time, and the number of calls can be
displayed on the readout.
The timers can also be cleared if necessary.
With beep tones you can be notified of the approxi­
mate talk time (NAM Option) in approximately 60
seconds increments.
To Display the Talk Time of the Last
Call
1 . Press IRCLi, key ® then [T].
The talk time of the last call will be displayed on
the readout for 5 seconds.
While in a conversation, the talk time of a call in
progress will be displayed, and updated each
second. The display format is as follows.
. 1 min. and 25 sec.
To Display the Cumulative Talk
Time
1. Press , key S then'
The cumulative talk time will be displayed on the
readout in minute format for 5 seconds.
i18m ...18 min.
To Display the Number of Calls
1. Press
The number of calls will be displayed on the
readout for 5 seconds. The display format is as
follows.
...Received or placed 86 calls.
To Clear the Timer
1. Press 0LRI, then enter the three-digit security
code.
2. Press ISTd . key then M .
The timers will be cleared, and the count for the
cumulative talk time and the number of calls will
start from zero.
One Minute Beep (NAM Option)
During conversation, you can be notified of the ap­
proximate talk time by tones for the first five minutes,
(a short monotone signal will sound every minute
and a double beep tone will be heard after approxi­
mately 5 minutes.)
28
29