Audiovox MVX-500 - Manual (Page 12)

PLACING TELEPHONE
CALLS
To Place a Call
1 .
2 .
3.
Enter the phone number. The last 15 digits of the
dialed number are displayed on the readout.
Note: After 120 sec., display will return to the 10-
digit display mode.
If a dialing error is made, press ICLRl, then enter
the phone number again. Pressing iCLRl mo­
mentarily (less than approx. 0.5 sec.) clears only
the last digit.
Press ISB^jPl. The Msj USBindicator will light. WTien
the called party answers, proceed with your
conversation.
Note: If assigned in NAM, the phone number can be
pre-set up to 32 digits. However, in this case it
is neccessary to confirm with system operator
whether such service is available or not.
If the Call Fails to Go Through
1. If you hear the “reorder” signal, press , then
if there were no dialing errors, press i^B^I for
redial. (Redialing with digit keys is not neces­
sary.)
2. Ifthe “intercept” signal is heard, press ^N0, then
redial the correct number.
Automatic Redial (NAM Option)
If the feature of Automatic Redial (NAM Option) is
selected, your unit will automatically make five
attempts to reach the cell site when the first try is not
successful. The
IN i^Sindicator will stay on, but the
speaker will be muted for twenty seconds. This is
done so that you do not hear the reorder signals out
of the speaker. If you need to terminate the automatic
redial, press l^'l^.
Terminating a Call
Press and the indicator will go out.
To Receive Calls
1. When the telephone rings, press to answer
the call. The WiJtlM indicator will light.
22
Silent Incoming Calls
This feature alerts you visually of an incoming call by
flashing IQAUJ on the readout instead of hearing the
Alert Tone.
1. Press , key 8 then O - The BJdfB will appear
on the readout.
2. When a call is received, the unit indicates it by
flashing feAkUnn the readout without Alert Tone.
3. Press to answer the call.
on the readout will go out. __
4. This mode is deactivated by pressingSS, key
then m again.
5. If the Silent Incoming Calls is activated when the
unit is powered up, will appear on the
readout for 5 seconds.
Any Digit Key Answering
(NAM Option)
This feature permits you to answer a call by pressing
any digit keys the same as pressing
Automatic Answering
With this feature, the incoming call will be automati­
cally connected for operation after two alert tones,
and the
mm indicator will light on the readout.
Then the unit is ready for conversation.
1
.
2-
3.
4.
To activate this mode, press BliOland then key S-
IJrAfWd will appear on the readout.
This mode is deactivated when and then key
m are pressed again.
This feature will not function if the unit is in the
Lock and Silent Incoming Calls.
If the Automatic Answering is activated when
the unit is powered up, will appear on the
readout for 5 seconds.
To Place a Call with a Number in the
Memory
1 . Press PyU, then enter the memory address (01
through 99). The last 10 digits of the number will
appear on the readout. If the number is longer
than 10 digits, hold down the second digit of the
memory address (after pressing PQU) to see the
prefix.
Note: See “To Recall a Number from Memory”
and “To Review the Prefix” for more de­
tails.
2. Press . The MIISB indicator will light
as the call is placed.
23