Citizen Systems PD-24 - Manual (Page 41)

41
4
*1: Link off
Function that cancels auto power off, during infrared linking
When IrDA is set, if the OS is Windows, the host PC performs a search (BroadCast) to clarify if there is or
is not an infrared device of some kind within the infrared communication range and a list of the devices is
displayed on the screen.
When the printer is powered by batteries, there may be no response and the names may disappear from
the PC screen because the power turns off during the period set by the power saving time setting.
If this setting is valid, Auto Power Off stops functioning and the host PC no longer overlooks the printer.
*2: Bluetooth mode
The connected device side may request validation. In such a case, set Bluetooth mode to BOND from
Menu setting mode (see page 35), to perform validation. During this operation, the entry of the PIN code
on the printer side is requested. The PIN code is allotted the lowest four columns of the BD address. If Self
printing is performed (see page 33), the BD address is printed, so refer to it to make the entry.
*3: BOND history deletion
When bonding has been done by Bluetooth, five BOND histories are usually stored inside. A device
formerly bonded based on this history can be connected without a PIN code.
If this setting is set to valid, the histories stored inside can be simultaneously erased.
The printer operates as follows.
1) “Valid” in the “Bond history deletion” menu is set and the VuePrint menu is closed. Then printer power
cuts off.
2) When power has been reconnected, the printer forcibly enters BOND history deletion mode and
BOND history is erased. Next printer power is automatically cut off.
3) When the power is turned on again, the BOND history deletion setting returns to its initial setting
“Invalid,” and the printer enters normal mode.
Remarks
Sets the stop bit
(Valid only for RS232C interface.)
Sets the flow control
(Valid only for RS232C interface.)
Sets the communication speed
of the Citizen infrared interface
Selects the stop bit of the
Citizen infrared I/F.
Sets Bluetooth mode
(Valid only for Bluetooth
interface)
Sets Bond history deletion
(Valid only for Bluetooth
interface)
Top Menu
Interface
settings
Sub Menu
Cable IF stop bit
Cable IF flow
control
IrCZ Baudrate
IrCZ stop bit
Bluetooth mode* 2
BOND history
deletion*
3
Initial values
1 bit
Xon/Xoff
9600
1 bit
Normal (no pin
code)
invalid
Setting range
1 bit
2 bit
Xon/Xoff
DTR/DSR
9600
19200
38400
1 bit
2 bit
Normal (no pin code)
Bond (with pin code)
Invalid
Valid
Setting the Modes