Hunter PRO-C (PCC) - Manual (Page 35)

35
Hidden Features
(continued)
Accessing the Soak Menu:
Once the desired Cycle times for each station have been
programmed, the Cycle time can be accessed by pressing the
n button.
The station will remain the same as was previously displayed
under the Cycle time (i.e. if station 2 is displayed in the Cycle
menu then Station 2 will be displayed upon pressing the
n button).
NOTE
The Soak menu cannot be accessed without a programmed
Cycle time.
Setting the Soak Time:
To access the other stations, press the h or i button.
NOTE
When changing the stations, if a station without a Cycle time
is encountered, the screen will revert back to the Cycle time.
Move to the next station with a Cycle Time and press the
n
button to return.
Once the desired station is displayed, the user can use
the j or k button to increase or decrease the Soak time.
The user can set the Soak time from 1 minute to 4 hours
in 1 minute increments.
NOTE
Before 1 hour, only minutes are displayed (e.g. 36). At 1 hour
or above, the display will change to include the hour digit
(e.g. 1:13 and 4:00).
Cycle and Soak Situations:
Station 1 requires 20 minutes of
watering, but after 5 minutes,
runoff occurs. However, after 10
minutes all the water is absorbed.
The solution would be to program
20 minutes for the station run time,
5 minutes for the Cycle time, and 10
minutes for the Soak time.
Example of Soak screen with
only minutes Example of Soak screen with
hours included
Station 10 cycle running