Hunter PRO-C (PCC) - Manual (Page 11)

11
Connecting Station Wires
1. Route valve wires between control valve location
and controller.
2. At valves, attach a common wire to either solenoid wire
of all valves. This is most commonly a white colored wire.
Attach a separate control wire to the remaining wire
of each valve. All wire splice connections should be
done using waterproof connectors.
3. Route valve wires through the conduit and attach conduit
to one of the openings on the bottom of the cabinet.
4. Strip ½" (13 mm) of insulation from ends of all wires.
Secure the valve common wire to “ COM” (Common) terminal.
Attach all individual valve control wires to the appropriate
station terminals.
NOTE
Common terminal screw has moved from base module
and is now below the sensor terminals. Do not connect the
incoming common wires to the PM/V terminal.
COM
1
2
3
4
Connecting Station Wires