Hunter PRO-C (PCC) - Manual (Page 34)

34
Hidden Features
(continued)
Cycle and Soak
The Cycle and Soak feature allows you to split a station’s
run time into more usable, shorter watering durations. This
feature is useful when applying water to slopes and tight soils
because it automatically applies water more slowly, helping to
prevent runoff from occurring. You should enter the Cycle time
as a fraction of the station’s watering time, and the Soak time
as the minimum number of minutes required before watering
can occur again for the next Cycle. The total number of cycles
is determined by taking the total programmed station run
time and dividing it by the Cycle time.
Accessing the Cycle and Soak Menu:
The Cycle and Soak feature is accessed by placing the dial
in the
RUN position, pressing and holding the j button for
3 seconds; while holding the j button rotate the dial to the
RUN TIME dial position, then release the button.
Setting the Cycle Time:
Initially Station 1 will be displayed. To access other stations,
press the h or i button.
Once the desired station is displayed, use the j or k button
to increase or decrease the Cycle time. The user can set the
time from 1 minute to 4 hours in 1 minute increments or to
OFF
if no Cycle is desired.
NOTE
Before 1 hour, only minutes are displayed (e.g. 36). At 1 hour
or above, the display will change to include the hour digit (e.g.
1:13 and 4:00).
If a station’s Run Time is less than or equal to the Cycle time,
then no Cycle will be applied.
Example of Cycle screen upon
entering Example of Cycle screen with
only minutes Example of Cycle screen with
hours included
Cycle and Soak