Using your bowflex ultimate, Using the bowflex ultimate, 2 adjustable pulley system – Bowflex Ultimate 2 User Manual
Page 8: Using the bowflex, Ultimate, 2 leg press belt
6
Using Your Bowflex Ultimate
®
2
Using the Bowflex Ultimate
®
2 adjustable pulley
system is as easy as pulling a pin and expanding
the pulley out.
Pulley knobs are spring-loaded and are located on
the back of the adjustable pulley system. To extend
the pulley, simply twist the knob a couple of turns
to the left, then pull out. Next, pull the adjustable
sleeve out away from the machine until it clicks into
the extended position. Then, tighten the knob to
lock the adjustable pulley into position.
The adjustable pulley system was designed to
change the angle of
resistance to increase
the effectiveness of
many upper body
exercises.
Use the pulley system
in either the wide
or narrow pulley
position. We’ve
included a guide
in each exercise so you can use the pulley at the
correct position.
To avoid injury, do not attempt to use the pulley
in the wide position when the manual indicates to
perform the exercise in the narrow pulley position.
Make certain the
adjustable pulley system
is locked and secure
before adding any
Power Rod
®
resistance
to the pulley.
Exercises in the wide
position may require a
lighter weight than those
in the narrow position.
The Bowflex Ultimate
®
2
adjustable pulley system
allows you to work the same
muscles from different
angles, depending on the
width of the pulley angle.
Using the Bowflex Ultimate
®
2 Adjustable Pulley System
The Leg Press Belt is used
exclusively for the Leg Press and
the Calf Raise exercises.
• With the Bowflex Ultimate
®
2
seat adjusted to the “free
sliding” position (spring lock
seat pin unlocked), the hand
grips removed, and the desired
amount of resistance hooked up,
sit on the seat and position the
leg press belt around your hips.
• Slide forward to the pulleys and
place your feet through the right
and left openings under the rod
cables.
• Attach the rod cables to the
D-rings on the Leg Press Belt so
that the belt is taut.
• Place hands on vertical
main frame
and
push yourself back
while placing feet,
one at a time, onto
the pulley frame.
• Grasp belt
near where
it’s attached to
the cables and
begin to press
back.
Using the Bowflex
Ultimate
®
2 Leg Press Belt