Bowflex Ultimate 2 - Manual (Page 7)

5
Using Your Bowflex Ultimate
®
2
Using the Bowflex Ultimate
®
2
Hand Grips
The Bowflex Ultimate ® 2
hand grips can be used
as regular grips, hand
cuffs or ankle cuffs.
Regular Grip: Grasp the handle
and cuff together to form a grip
without inserting your hand
through the cuff portion. Most of
the exercises you perform utilize
this grip.
Hand Cuff Grip: Slip your hand
through the cuff portion of the
grip so that the foam pad rests
on the back of your hand. Then
grasp the remainder of the grip
that is sitting in your palm. This
method of gripping is great for
exercises like front shoulder
raises or any exercise where your
palm is facing down.
Ankle Cuff Grip: The cuff
opening can be made larger to
accommodate the ankle. Simply
insert your hand in the cuff and
slide it away from the handle.
Insert your foot or ankle and
tighten the grip by sliding the
handle back toward the cuff.
The Workout Bench
Your Bowflex Ultimate ® 2 home gym has four
different bench positions. To adjust the bench,
simply locate the spring lock pin on the side of the
seat. Pull out pin to release seat, then slide it to the
desired position. Pull out pin, give it half a turn, and
release to place it in a “free sliding” position for
exercises such as rowing.
Quick Release Bench: The long portion of your
bench attaches to and releases from the seat
portion very easily. To attach it, simply insert the
half hinge on the end of the bench into the half
hinge on the seat. For standing exercises, simply
remove the bench by lifting up on the long portion
and pulling away from the seat.
Flat Position:
Along the side
of the seat rail
there are three
holes for the
spring lock seat
pin. Pull out
on the pin and
slide the entire bench forward until the spring lock
seat pin locks into a hole. With the bench in the flat
position, there are two possible holes for the spring
lock pin to lock into, one
forward and one back.
Incline Position: Start
with the bench flat in the
furthest position away
from the Power Rod ® units.
Pull out on the spring
lock seat pin and lift the
long bench pad up. Slide
forward until the pin locks
into the farthest forward
hole. Rest the bench’s incline support bracket on the
base of the Power Rod ® units.
“Free Sliding”
Position:
Remove the
long bench
pad. Pull out
on the spring
lock seat pin,
Grips manufactured under license agreement with Hands-On Sports & Gym Accessories, Inc. Patent #4756527