NETGEAR Universal WiFi Internet Adapter WNCE2001 User Manual
Page 17
Chapter 2. Advanced Settings
|
17
Universal WiFi Internet Adapter WNCE2001
To join a network using WPS after installation:
1.
From the Internet adapter menu at http://www.mywifiext.net, under the Setup heading,
select WPS. The following screen displays:
2.
Select a radio button.
•
Push and Connect (recommended)
. Either click the
button or press the WPS
button on the rear panel of the Internet adapter.
•
PIN Number
. Select the radio button and a PIN displays.
The Internet adapter tries to join the wireless network for 2 minutes if you are using Push
'N' Connect, or 4 minutes if you are using a PIN.
3.
Go to the router.
•
If you are using Push 'N' Connect, press the router’s WPS button.
•
If you are using a PIN, log in to the router and type the PIN from your Internet adapter
in its WPS screen.
4.
Go back to the computer that is connected to the Internet adapter, and make sure that you
are connected to the wireless network.
•
When WPS is running, the WLAN LED blinks, alternating between green and amber.
•
If the computer does not to connect with WPS, the WLAN LED is solid red for 5
seconds.
•
If the computer does connect using WPS, the WLAN LED is solid green for 5 seconds
Then the WLAN LED returns to indicating a wireless signal.