Motorola sb6120 - Manual (Page 2)

i
SAFETY AND REGULATORY INFORMATION
IMPORTANT SAFETY INSTRUCTIONS — when using your equipment, basic safety precautions
should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the
following:
•
Read all of the instructions listed here and/or in the user manual before you operate this
device. Give particular attention to all safety precautions. Retain the instructions for future
reference.
•
This device must be installed and used in strict accordance with manufacturer’s instructions
as described in the user documentation that is included with the device.
•
Comply with all warning and caution statements in the instructions. Observe all warning and
caution symbols that are affixed to this device.
•
To prevent fire or shock hazard, do not expose this device to rain or moisture. The device
must not be exposed to dripping or splashing. Do not place objects filled with liquids, such as
vases, on the device.
•
This device was qualified under test conditions that included the use of the supplied cables
between systems components. To ensure regulatory and safety compliance, use only the
provided power and interface cables and install them properly.
•
Different types of cord sets may be used for connections to the main supply circuit. Use only
a main line cord that complies with all applicable device safety requirements of the country of
use.
•
Installation of this device must be in accordance with national wiring codes and conform to
local regulations.
•
Operate this device only from the type of power source indicated on the device’s marking
label. If you are not sure of the type of power supplied to your home, consult your dealer or
local power company.
•
Do not overload outlets or extension cords, as this can result in a risk of fire or electric shock.
Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked wire
insulation, and broken plugs are dangerous. They may result in a shock or fire hazard.
•
Route power supply cords so that they are not likely to be walked on or pinched by items
placed upon or against them. Pay particular attention to cords where they are attached to
plugs and convenience receptacles, and examine the point where they exit from the device.
•
Place this device in a location that is close enough to an electrical outlet to accommodate the
length of the power cord.
•
Place device to allow for easy access when disconnecting the power cord of the device from
the AC wall outlet.
• Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can
be fully inserted with no part of the blades exposed.
•
Place this device on a stable surface.
•
It is recommended that the customer install an AC surge protector in the AC outlet to which
this device is connected. This is to avoid damaging the device by local lightning strikes and
other electrical surges.
•
Postpone installation until there is no risk of thunderstorm or lightning activity in the area.
•
Do not cover the device, or block the airflow to the device with any other objects. Keep the
device away from excessive heat and humidity and keep the device free from vibration and
dust.
•
Wipe the device with a clean, dry cloth. Never use cleaning fluid or similar chemicals. Do not
spray cleaners directly on the device or use forced air to remove dust.