Shift lever installation, Note, Handle panel installation – MTD 215-386-000 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

4. Shift Lever Installation

The shift lever is mounted to the handle panel in

the following manner.

Place the top hole of the shift lever over weld

------- bolt on handle panel. See figure 7.

B Place belleville washer (F) and spring (G) over

weld bolt as shown in figure 7.

C. Secure with hex lock nut (H). See figure 7.

NOTE

Thighten hex lock nut just to the

point the spring starts to compress.

FIGURE 7.

5. Handle Panel Installation

Thread adjustment ferrule (D) on end of control

rod. Hook the other end of control rod into the tab

on idler arm. Secure with hairpin cotter (C). See

-figure

Slip other end of control rod with ferrule attached
through the slot in handle panel. Then slide the

handle assembly down over the handle mount

-brackets on the chassis. See figure 9.