Ahaching the engine and pump assembly, Ahaching the control handle, Ahaching the hoses – MTD 241-521-000 User Manual
Page 7: Final assembly, Figure 9, Suction hose, Return hose, Pressure hose
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Engine
Beam
Hinge
Pin
FIGURE 7.
Cylinder
Hex Bolts'
Lock Washers
Hex Nuts
Engine
Mounting'
Bracket
Control
Handle
’S
FIGURE 9.
AHACHiNG THE ENGINE AND PUMP ASSEMBLY
1.
Using
two
Va"
wrenches,
remove
the
four
hex
bolts,
lock
washers
and
hex
nuts
which
secure
the
base
of
the
engine
to
the
bottom
of
the
shipping
carton.
2.
Place
the
engine
and
pump
assembly
in
position
on the side of the reservoir tank assembly as
--------- shown in figure 7. Secure with hardware just
removed. Tighten securely.
AHACHING THE CONTROL HANDLE
1.
The control handle is taped to the stripper half for
shipping purposes only. Remove the tape.
2.
The
bottom
of
the
control
handle
is
already
at
tached
to
the
valve.
Remove
the
cotter
pin
and
clevis
pin
which
are
attached
to
the
valve.
Place
the handle in position, and secure to the valve
----------using the cotter pin and clevis pin. See figure 8.
AHACHING THE HOSES
Suction Hose
1. The suction hose is attached to the reservoir tank.
--------- See figure 9. Loosen the hose clamp on the free
end of the hose using a screwdriver.
2.
Attach the end of the hose to the fitting on the bot
tom of the pump. Place the hose clamp at the base
of the fitting, and tighten securely.
Return Hose
1.
The return hose is attached to the top of the valve.
Loosen the hose clamp on the free end of the hose
using a screwdriver.
2.
Attach the end of the hose to the fitting on top of
the filter head. See figure 10. Place the hose clamp
at the base of the fitting, and tighten securely.
Pressure Hose
The pressure hose is attached to the top of the pump.
-Route
the
hose
as
shown
in
figure
10.
Secure
the
pressure
hose
to
the
bottom
of
the
control
valve,
using
an adjustable wrench.
FINAL ASSEMBLY
1.
Make
certain
all
nuts,
bolts
and
hose
clamps
are
tightened securely.
2.
Before
operating
the
log
splitter,
make
certain
to
follow “Initial Preparation” instructions.