MTD 24677A User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UPPER
HANDLE (O)-
I
LOCK NUT (
FIGURE 4.
STUD PIN
( K i
UPPER
HANDLE
2. Place the upper handle (0) in position over lower
handle. Fasten with four hex bolts (I) and lock
nuts (J) provided. See figure 4. Two 7/16"
wrenches are required.
Place the stud pins (K) in holes in upper handle
(head of pins go to the inside of handle). Secure
pins with push-on speed nuts (L) by holding
speed nut with box wrench and tapping pin with
hammer. See figure 5.
FIGURE 5.
BELLEVILLE
WASHER (G)-
HAND
KNOB (F)
DUCl
EMBLY (P)
4. Place air duct assembly (P) over opening on top
of housing. Secure with two hand knobs (F) and
belleville washers (G). See figure 6.
FIGURE 6.