Generac Power Systems 009600-4 - Manual (Page 22)

GENERAL
INFORMATION
Section 5 - General Information
PRIMEPACT 66G and 66LP Recreational Vehicle Generators
5.1 PURPOSE ÄND SCOPE OF THE
INSTALLATION INSTRUCTIONS
These Installation Instructions have been prepared
especially for the purpose of familiarizing installers and
owners of the applicable equipment with the product's
installation requirements. Give serious consideration to
all information and instructions in the manual, both for
safety and for continued reliable operation of the equip­
ment.
Because of the different recreational vehicle models and
the variations between the models, it would be extremely
difficult, if not Impractical, to provide detailed instruc­
tions for every possible installation. For that reason,
instructions and illustrations in this manual are general
in nature. Illustrations are not intended to serve as
detailed installation blueprints.
The installation should comply strictly with all applica­
ble codes, standards and regulations pertaining to the
installation and use of this product. If any portion of
this manual appears to be in conflict with such codes,
standards
or regulations, the applicable codes, stan­
dards or regulations must take precedence over the
manual.
5.2 SAFETY
Before handling, installing, operating or servicing this
equipment, carefully read the “Notice to Installer” and
“Safely Rules” on Pages 18 and 19. Comply with all safe­
ty rules to prevent death, personal injury or damage to
equipment
and/or property. Stress safety to all
installers, operators and service technicians who work
on this equipment.
5.3 STANDARDS BOOKLETS
Installation, use and servicing of this equipment should
comply strictly with published standards, as well as the
manufacturer's
recommendations. The following stan­
dards booklets (latest revision) are available from the
sources indicated:
1. NFPA Standard 501C, "Standard for Recreational
Vehicles,” available from the National Fire
Protection Association, Batterymarch Park, Quincy,
MA 02269.
2. NFPA 70, “NFPA Handbook of the National Electric
Code," available same as Item 1.
3. ANSI Cl-1975 and ANSI 119.2-1975, available from
the American National Standards Institute, 1430
Broadway, New York, NY 10018.
4. ANSI A119.2/NFPA 501C, available from the
Recreational Vehicle Association, 1896 Preston
White Drive, Reston, VA 22090.
5. California Administrative Code, Idtle 25, available
from the State of California, Documents Section,
PO. Box 1015, North Highlands, CA 95660.
20 Generac* Power Systems, !nc.
6. CSA Electrical Bulletin 946, available from the
Canadian Standards Association, Housing and
Constructions Materials Section, 178 Rexdale
Boulevard, Rexdale, Ontario, Canada, M9W 1R3.
5.4 EQUiPIVIENT DESCRIPTION
Instructions and information in this section pertain to
Generac
air-cooled generators. These generators are
designed specifically for installing in recreational vehi­
cles. They operate 120-volt, single-phase, 60-Hertz, AC
electrical loads that require 55.0 amps (gasoline) or
51.7 amps (LP fuel) at 120 volts.
5.5 GENERATOR ENGINE
OPERATING SPEED
The generator’s revolving field (rotor) is driven by a sin­
gle-cylinder, four-cycle engine through a pulley and drive
belt arrangement. The generator supplies 120 volts AC
at 60 Hertz when the rotor is operating at 3,600
rpm.The drive belt arrangement allows the engine to
operate at a lower speed than the rotor.
5.6 GENERATOR AC
CONNECTION SYSTEM
These air-cooled generator sets are equipped with dual
stator AC power windings. These two stator windings
supply electrical power to customer electrical loads by
means of a dual 2-wire connection system.
Generators may be installed to provide the following
outputs:
1) 120 VAC loads only — one load with a maximum total
wattage requirement equal to the generator’s rated
power output (in watts), and 120V across the generator
output terminals. (See Fig. 5.1 below)
2) 120/240 VAC loads — one load with a maximum total
wattage requirement equal to the generator’s rated
power output, and 240 V across the generator output
terminals; or two seperate loads, each with a maximum
total wattage requirement equal to half of the genera­
tor’s rated power output (in watts), and 120 V across
the generator output terminals. (See Fig. 5.3 on page 22)
Figure 5.1 - Connection for 120 Volts Only
GROUNDED
NEUTRAL