beautypg.com

Opfratson, To operate mower (see fig. 8), To operate on hills – Poulan 169553 User Manual

Page 12: To transport

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

■OPFRATSON

TO,

JUS

wh€

T GAUGE WHEEI

iFîa

Gauge wheels

are

properly adjusted when they

are

slightly

off the

ground

when mower is at the desired

cutting height in

' I -f-lir fs r,'.- id

'Svf

(h.

,

t>i

!’•» I'd (. i ( r f Ijt- -.rr • -i| •!,, , |.,** i '• i!l

conditions.

Adjusi gaug'-. uhte's Witt>

n a il« le%el .^usface

' Adjust

lo dfesued c.J«i->g r(e«giii (Ste ‘T'J AfuLihi

MOWER ('U FTiNG HEKyHT -n ft*#* i5p«ra‘ior> s«=—tjon of >hi..

manual}.

With mower in desired height of cut position, gauge wheels

should be assembled so they are slightly off the ground.

Install gauge wheel in appropriate hole with shoulder bolt, 3/

8 washer, and 3/8-16 locknut and tighten securely.

Repeat for opposite side installing gauge wheel in same

adjustment hole.

TO OPERATE MOWER (See Fig. 8)

Your tractor is equipped with an operator presence sensing

switch. Any attempt by the operatorio leave the seat with

the engine running and the attachment clutch engaged will

shut off the engine.

« Select desired height of cut.

*

Lower mower with attachmenr lift control.

*

Start mower blades by engaging attachment clutch control.

® TO STOP MOWER BLADES - disengage attachment clutch

control.

A

CAUTION: Do not operate the mower

without either the entire grass catcher,
on mowers so equipped, or the dis­
charge guard in place.

TO OPERATE ON HILLS

A

CAUTION: Do not drive up or down
hills with slopes greater than 15° and

do not drive across any slope. See the

slope guide in the back of this manual.

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If slowing is necessary, move throttle control lever to slower

position.

It stopping is absolutely necessary, push clutch/brake

pedal quickly to brake position and engage parking brake.

Move gearshift lever to 1st gear and be sure you have

allowed room for tractor to roll slightly as you restart move­

ment.

® To restart movement, slowly release parking brake and

clutch/brake pedal.

® Make all turns slowly.

TO TRANSPORT

Raise attachment lift to highest position with attachment lift

control.

When pushing or towing your tractor, be sure gearshift lever

is in neutral (N) position.

» Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting

your tractor on a truck ora trailer, be sure hood is closed and

secured to tractor. Use an appropriate means of tying hood

to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the adachrr.ents that are fecomrnended by ard

comply with soecifications of the manutocturer cf your
tractof. Use common sense when sowing Too heamr

ct

a

load, while on a slope, is dangerous. Tires car lose Ira-ction
with the ground and cause you to lose control of yourtractor.

12