Christie Digital Systems XENON CONSOLE - Manual (Page 32)

S L C S e r i e s X e n o n C o n s o l e
7-2 CHRISTIE DIGITAL SYSTEMS
August 7, 2003
WARNING
Always remove the lamp before cleaning the reflector.
7 . 2 . 1 . C
L E A N I N G
D
U S T
For surfaces that are dusty but do not have smudges, fingerprints, or grease marks:
1. Brush dust from surface with camel-hair brush.
2. Blow remaining dust away with compressed air.
7 . 2 . 2 . C L E A N I N G G R E A S E
For surfaces that are smudged or have oil or grease smears:
1. Moisten cotton pad with light detergent solution. Pad should be well moistened but not
dripping wet.
2. Gently swab exposed lens or mirror surface, using spiral motion and working from center
outward toward edge of surface.
3. Sponge up moisture with cheesecloth or lens tissue.
Always sponge with fresh cheesecloth or lens tissue. Do not wipe with
material that has been used before. Throw cheesecloth or lens tissue away
after one use.
4. Dampen cotton pad with methyl alcohol. Wipe surface, using spiral motion from center
to edge, in one continuous motion.
5. Dry exposed surface with dry cotton pad or with lens tissue.
6. Repeat procedure above as required.
7. When exposed lens or mirror surface is dry and clean, loosen any remaining lint with
brush and blow clean with compressed air.
7.3. M
A I N T A I N I N G
O
T H E R
S
U R F A C E S
Surfaces other than the optical surfaces require periodic maintenance to keep the lamphouse
in good operating condition. These items are:
• Blower
• Igniter
• Air flow interlocks.