MTD 112-530A - Manual (Page 6)

Throttle
Control
Screws (D)
2. Place throttle control up through slot provided
in handle panel. Secure with two screws (D).
— See figure 7.
3. Secure throttle control wire to handle using
cable ties (C).
FIGURE?.
f
Control
Rod
Ferrule (
CONTROL ROD INSTALLATION
1. Pull pivot bracket up as far as it will go. See
----- figure 8. Place ferrule (H) through hole in pivot
bracket. Thread control rod into ferrule ap­
proximately one-half inch.
FIGURE 8.
2. Hook control rod into hole provided in lockout
lever assembly (O). Hold lockout lever in a
raised position as shown in figure 9. Thread
control rod in or out of ferrule as necessary
until hole in lockout lever lines up with hole in
— lockout bracket. See figure 9.
3. When correct adjustment is reached, secure
lever to bracket using hex bolt (L), flat washer
(M) and hex lock nut (N).
FIGURES.
NOTE
Check control rod adjustment. A
slight pressure should be needed to
operate lockout lever. Too much
pressure can break lever assembly
or control rod. Readjust control
rod if pressure is too great.