MTD 112-530A - Manual (Page 12)

Clean
Electrode
13. Position belt bracket on idler pulley to clear
the tightened belt. Secure belt bracket in posi­
tion. See drawing on page 13.
14. Replace blade spindle cover.
NOTE
To insure safe operation of your
unit, ALL nuts and bolts must be
checked periodically for correct
tightness.
OFF-SEASON STORAGE
FIGURE 18.
.030"
ler Gauge
The following steps should be taken to prepare
lawn mower for storage.
1. Clean and lubricate mower thoroughly as
described in the lubrication instructions.
2. Refer to engine manual for correct engine
storage instructions.
3. Coat mower’s cutting blade with chassis
grease to prevent rusting.
4. Place blocks under deck to raise tires clear of
floor.
5. Store mower in a dry, clean area.
FIGURE 19.
BELT REPLACEMENT
Belt replacement may be made as follows:
1. Remove blade spindle cover.
2. Remove front belt guard.
3. Remove blade tension spring.
4. Loosen belt on bracket of idler bearing
assembly.
5. Remove bracket lever assembly.
6. Remove damaged or worn belt.
7. Place new belt on engine pulley. Do not bend
belt guard pins. Belt should be inside of pins.
8. Work belt to front and mount on blade spindle
pulley. Replace front belt guard.
9. Replace brake lever assembly.
10. Slip belt on idler pulley between pulley and
belt bracket.
11. Replace blade tension spring.
12. Move blade lockout handle to “ON” position.
12