MTD 24635A - Manual (Page 8)

UUihiiiiMmtíM
FIGURE 15
13. Reassemble with new belts, following instructions
in reverse order.
NOTE
When reassembling the frame halves, be
certain that the jackshaft bearing is
properly seated into the hole in the
front frame. Secure frame halves with
one top and bottom bolt, finger tight
only. Check position of bearing. Then
reassemble rest of bolts, tightening
securely.
‘NOTE
Belts and chain must be reassembled as
shown in illustration on page 10. If
assembled incorrectly, log splitter will
operate in reverse.
OFF-SEASON STORAGE
In event engine is to be stored for any length of time
(30 days or more), prepare as follows:
1. Drain gasoline by tipping or by siphon hose, then
run engine until remainder is used and tank and
carburetor are empty.
A CAUTION
3.
4.
Drain into container outdoors away
from fire or flame.
Drain carburetor by running engine until it stops
from lack of fuel.
Protect the inside of engine for storage by
removing spark plug and pouring one ounce of
SAE 30 oil through spark plug hole into cylinder.
Crank engine, without starting, several times to
spread oil over cylinder walls.
Never store outside without a waterproof cover.