MTD 24635A User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MASTER LINK
FIGURE 10
8.
Remove the two belt keepers on the right hand
side of frame using two 7/16" wrenches. See
figure 11.
10. Block up the front of the frame as shown in figure
13. Remove the three bottom bolts, lock washers
and nuts. See figure 13.
FIGURE 11
9. Remove the top three bolts, lock washers and nuts
as shown in figure 12. Two 9/16" wrenches are
required.
THREE TOP BOL
FIGURE 13
11. Lift up on the rear frame so it will clear the
large sprocket. Pull back to separate front and
rear frames. See figure 14.
REAR FRAME
LARGE
SPROCKET
FRONT FRAME
FIGURE 14
FIGURE 12
12. Slip belts between jack shaft bearing and front
frame. See figure 15.