MTD 24635A - Manual (Page 5)

NOTE
If the wedge assembly becomes
jammed, turn the jack shaft spindle
assembly counterclockwise until the
wedge can be returned. See figure 3.
A large adjustable wrench is required.
JACK SHAFT SPINDLE
ASSEMBLY
FIGURE 3
WARNING
Never attempt to cut a log in half
against the grain (cross ways). Never
stand next to the log when operating
the splitter.
ADJUSTMENTS
CARBURETOR ADJUSTMENTS
t warning !
If any adjustments are made to the
engine while the engine is running
(e.g. carburetor), disengage all clutches.
Keep clear of all moving parts. Be
careful of heated suVfaces and muffler.
Refer to engine manual packed with your unit for
carburetor adjustment information.
CHAIN ADJUSTMENT
The chain must be adjusted after the first hour of
/•^“^ial operation and every ten hours thereafter.
adjust the chain, loosen the two nuts shown in
figure 4. Place a screwdriver on the chain adjuster as
shown in figure 4. Pivot the chain adjuster by pulling
downward on the screwdriver to take the slack out of
the chain. Tighten the two nuts.
FIGURE 4
MAINTENANCE
®
\ WARNING \
Always stop engine and disconnect
spark plug wire before performing any
maintenance or adjustments.
ENGINE OIL
Change oil first two (2) hours of operation and check
oil level every five (5) operating hours or each time
equipment is used.
Change oil every twenty-five (25) operating hours or
sooner if equipment is operated in extremely dusty or
dirty conditions.
Refer to engine manual for quantity and type of oil.
WEDGE AND SCREW ASSEMBLY
Lubricate the two screws on the wedge and screw
assembly with engine oil every two operating hours or
more often if necessary.
BELT REPLACEMENT
NOTE
If belt replacement is required, it is
advisable to replace both belts at the
same time,
NOTE
Reference to right or left hand side of
the unit is determined when standing
behind the unit, at the engine.
It is suggested that all instructions be read through
before beginning belt replacement.
1. Disconnect and ground the spark plug wire against
the engine block.
2. Using a 1/2" wrench, remove the top cover by
removing the five self tapping screws which secure
it to the side covers.